| |
52" Lawson Pacemaker II with Micro Cut
|
- 52" Cut Width
- 2 Side Wing Tables (Not
Pictured)
- Micro Cut Backgauge
Controls Standard Features:
- Modular, solid
state circuitry
- Patented
independent DC motor drive
-
Microprocessor-controlled, infinitely variable backgauge drive
- Repeatability of
backgauge position to +/-.002 inches (.05 mm)
- Automatic backgauge
return
- Operator-defined
inch or metric display
- Program entry or
correction, through the keyboard with the backgauge stationary
or while cutting the lift
- Automatic
computation and entry of fractions
- Insertion or
deletion of commands from existing programs
- Stock eject,
turnaround, loading points and job information
- Infinite lay
compensate mode for as many sides as requested
- Non-volatile memory
no batteries required for memory support
- Optional auxiliary
controls for air and/or brake
- Minimum trim cut:
.002 inch (.05 mm)
- Speed range: 24 -
960 inches per minute, both forward and reverse, depending on
size and condition of cutter
- Self-diagnostic
electronics
- Electrical: 85 -
265 VAC, 50/60 Hz @ 1 KVA
- Double End Pull Knife
Motion
- Hydraulic Knife and
Clamp Motion
- 2 Knives
- Power Clamp
- 220 Volt
|
|